Panasonic KX-NS500 Pc Programming Manual

2.1.5 Card Status
Certain tools, utilities and settings require that the target card be set to out-of-service (OUS) or in-service
(INS) status before the operation is carried out. Where required, this is noted in the description of each item.
Card status changes can be performed only in On-line mode (see Programming Modes in
1.1.2 Introduction).
• "In service" means that the card is installed correctly in the PBX, and is capable of being used normally.
• "Out of service" means that the card is installed correctly in the PBX, but has been temporarily removed
from use. This allows settings to be modified or software to be upgraded.
• "Fault" means that the card is not installed in the PBX correctly, or is not functioning correctly. For more
information, see the Installation Manual.
For details about how to change the status of a card, see To change the status (INS/OUS) of a card (On-line
mode only) in 9.1 PBX Configuration—[1-1] Configuration—Slot.
PC Programming Manual 39
2.1.5 Card Status

Panasonic KX-NS500 Specifications

General

Analog Extensions	Up to 64
VoIP Support	Yes
System Type	Hybrid IP-PBX
Power Supply	AC 100-240V, 50/60Hz
Operating Temperature	0°C to 40°C
Humidity	10% to 90% (non-condensing)
Maximum Extensions	288
IP Extensions	128
VoIP Channels	64
SIP Trunks	64
Networking	Yes, supports networking
Built-in Applications	Call Center
Expandability	Yes, via expansion cards and cabinets
Supported Protocols	SIP, H.323, MGCP
Dimensions	430 x 88 x 367 mm