Mailbox transport drive jam service check
Action Yes No
Step 1
Make sure that all the optional bins are properly installed.
Does the problem remain?
Go to step 2. The problem is
solved.
Step 2
Open all optional bin doors, and then check the paper path and
bins for paper fragments and partially fed paper.
Is the paper path free of paper fragments and partially fed paper?
Go to step 4. Go to step 3.
Step 3
Remove the paper fragments and partially fed paper.
Does the problem remain?
Go to step 4. The problem is
solved.
Step 4
Clear the optional bin paper path rollers of any dirt and
contamination.
Does the problem remain?
Go to step 5. The problem is
solved.
Step 5
a Enter the Diagnostics menu, and then navigate to:
Output bin quick feed > Feed to all bins
b To uc h Single or Continuous.
Does the problem remain?
Go to step 6. The problem is
solved.
Step 6
a Remove the mailbox left cover. See “Mailbox left cover
removal” on page 654.
b Reseat the cable on the motor (mailbox transport) and on the
mailbox controller board.
Does the problem remain?
Go to step 7. The problem is
solved.
Step 7
Check the motor (mailbox transport) for improper installation and
damage.
Is the motor properly installed and free of damage?
Go to step 9. Go to step 8.
Step 8
Reinstall or replace the motor. See
“Motor (mailbox transport)
removal” on page 666.
Does the problem remain?
Go to step 9. The problem is
solved.
4064
Diagnostics and troubleshooting
208
To Next Page
Loading...
Need help?
General
