Actions Yes No
Step 3
Measure the distance between repeating defects, and then check
if it matches any of the following:
• 3.71 in. (94.25 mm)
• 3.75 in. (95.2 mm)
Does the distance measured match any of the items listed?
Go to step 4. Contact the next
level of support.
Step 4
Replace the fuser. See
“Fuser removal” on page 452.
Does the problem remain?
Go to step 5. The problem is
solved.
Step 5
Replace the transfer roller. See
“Transfer roller removal” on
page 447.
Does the problem remain?
Contact the next
level of support.
The problem is
solved.
Skewed print check
Note: Before performing this print quality check, go to the control panel home screen and navigate to
Settings > Troubleshooting > Print Quality Test Pages, and then perform the initial print quality check. See
“Initial print quality check” on page 44.
Actions Yes No
Step 1
Check the guides in the tray where the skewed prints are sourced
from.
Note: If paper is sourced from the MPF, then proceed to step 9.
Does the position of the guides match the paper loaded?
Go to step 3. Go to step 2.
Step 2
Adjust the guides to match the paper loaded.
Does the problem remain?
Go to step 3. The problem is
solved.
4064
Diagnostics and troubleshooting
60
To Next Page
Loading...
Need help?
General
