Entering invalid engine mode
This mode is used if the machine has invalid code and needs the correct code loaded. After entering this mode,
the firmware code can be updated.
1 Turn o the printer.
2 Press and hold the 3, 4, and 6 buttons simultaneously.
3 Turn on the printer.
4 Release the buttons after 10 seconds.
Entering recovery mode
This mode will allow the printer to boot from a secondary set of instructions to allow a code flash to the printer.
Code can be flashed from a PC by USB.
1 Turn o the printer.
2 Press and hold the 7, 2, and 8 buttons simultaneously.
3 Turn on the printer.
4 Release the buttons after 10 seconds.
Accessing the Network SE menu
This menu contains settings for
fine
‑tuning the communication settings for the network interfaces and protocols.
1 Navigate to:
Networks/Ports > Standard Network > Std Network Setup
2 Press and hold the 6, 7, and 9 buttons simultaneously.
Service Engineer menu
Accessing the service engineer (SE) menu
From a Web browser on a host PC, add /se to the printer IP address.
Service engineer (SE) menu
This menu should be used as directed by the next level of support.
Top‑level menu Intermediate menu
Print SE Menus
General Copyright — Displays copyright information
4064
Service menus
389
To Next Page
Loading...
Need help?
General
