Fig 6-7 Bearing cover - install
00616
007
006
003
004
001
002
005
14 Attach the shackle 94019K (004, Figure 6-8) to the lug 94116C (003).
15 Attach engine room crane to the shackle 94109K (004).
16 Operate the engine room crane to move the bearing cover to an applicable position on
the platform.
17 Attach the chain block (002) to the shackle (001) and the lug (003).
18 Operate the engine room crane and the chain block (002) to move the bearing cover
above the crankshaft.
19 Lower the bearing cover (003) on to the bearing girder (005). Make sure that the two
spring dowel pins (001) engage correctly. Make sure that you do not cause damage to
the elastic studs (004)
NOTE: The top bearing shell is attached to the bearing cover (003, Figure 6-7) with
two Allen screws (002). The spring dowel pins (001) help to get the bearing
cover in position during installation.
20 Remove the thrust device, refer to the name plate.
21 Install the round nuts (006) on the elastic studs (004), refer to section 4.2 Tighten a
round nut with a pre-tensioner.
22 Remove the engine room crane from the shackle (011, Figure 6-8).
23 Remove the shackle (011) from the lug (010).
24 Remove the chain block (012) from the lug (010).
25 Remove the lug (003).
X72DF
AA00-1132-00AAA-720A-A
Maintenance Manual Main bearing - install the cover
Winterthur Gas & Diesel Ltd.
- 112 - Issue 002 2020-10
To Next Page
General
