3.2 Jointing compounds
Tab 3-2 Jointing compound
Jointing compound Hardener Adhesive primer Manufacturer
Elastosil RT 622 A RT 622 B G 790 Wacker-Chemie GmbH
Geschäftsbereich Silicone
Hanns-Seidel-Platz 4
D-81737 München
Silcoset 105 RTV Silcoset Curing
Agent A
Silcoset Primer Ambersil House Ltd.
Wylds Road
Bridgwater Somerset TA6 4DD
England
NOTE: Use only the data in the related manufacturer’s instructions to mix and apply the
jointing compounds, hardeners and adhesive primers.
Materials from other manufacturers are permitted, but must have the qualities as follows:
•
The materials must not contain acid.
•
The materials must be resistant to oil, marine diesel oil, heavy fuel oil and water at a
temperature of 100°C.
•
A short age-hardening time is necessary, that is not more than 24 hours (refer to the data
in the ISO standard reference conditions).
•
The materials must flow easily to fill the area around the sealing surface (that is no air
pockets).
•
The materials must have good adhesion qualities on primed metal surfaces.
•
The materials must be easy to prepare and combine.
•
The surface shrinkage must be very small, or none.
•
The jointing compound must stay in an elastic condition. This will help you if it becomes
necessary to remove the elastic studs.
X72DF
AA00-0000-00AAA-701A-A
Maintenance Manual Jointing compounds
Winterthur Gas & Diesel Ltd.
- 60 - Issue 002 2020-10
To Next Page
General
