Xerox Phaser 790 User Manual

10/00
4-5
Phaser 790/DocuColor 2006
REP 1.1, REP 1.2
Repairs and Adjustments
Initial Issue
REP 1.1 LVPS
Parts List on PL 11.1
Removal
WARNING
To avoid personal injury or shock, do not perform repair activities with the power switch
on or electrical power applied to the machine.
1. Switch off the machine power and disconnect the machine Power Cord.
2. Remove the Rear Cover (REP 14.6).
3. Remove the LVPS (Figure 1).
Replacement
CAUTION
Be careful not to get the harness caught in the gears or damaged on sharp sheet metal when
installing the LVPS.
Be sure to hook the LVPS securely on the left side of the frame when Installing.
1. Reinstall the LVPS in the reverse order of removal.
Figure 1 Removing the LVPS
REP 1.2 HVPS
Parts List on PL 11.1
Removal
WARNING
To avoid personal injury or shock, do not perform repair activities with the power switch
on or electrical power applied to the machine.
1. Switch off the machine power and disconnect the machine Power Cord.
2. Remove the Rear Cover (REP 14.6).
3. Remove the HVPS (Figure 1).
Replacement
CAUTION
Be careful not to get the harness caught in the gears or damaged on sharp sheet metal when
installing the HVPS.
1. Reinstall the HVPS in the reverse order of removal.
Figure 1 Removing the HVPS
2
Loosen the lower
screws
1
Disconnect the
Connectors
3
Remove the
upper screws (2)
emove the
VPS
1
Disconnect
the six con-
nectors
2
Remove the screws
3
Remove the
HVPS

Xerox Phaser 790 Specifications

General

Brand	Xerox
Model	Phaser 790
Category	Copier
Language	English