10/00
4-108
Phaser 790/DocuColor 2006
REP 9.20
Initial Issue
Repairs and Adjustments
REP 9.20 Auger
Parts List on PL 7.1
Removal
WARNING
To avoid personal injury or shock, do not perform repair activities with the power switch
on or electrical power applied to the machine.
1. Switch off the machine power and disconnect the machine Power Cord.
2. Open the Bypass Tray / Registration Assembly (REP 8.6).
3. Remove the Locating Rail (REP 9.3).
4. Remove the Fuser Assembly (REP 10.1).
5. Remove the Belt Cleaner (REP 9.17).
6. Remove the BTR 2 Assembly (REP 9.18).
7. Remove the BTR Cam Clutch (REP 9.23).
8. Remove the HVPS (REP 1.2).
9. Remove the Process Drive Unit (REP 4.6).
10. Remove the IBT Assembly (REP 9.16).
11. Remove the BTR 2 Cam Assembly (REP 9.19).
12. Remove the Right Cover (REP 14.9).
NOTE: Toner may spill from the Auger during the removal. Spread paper on the frame below
the Auger and be careful not to spill toner.
13. Remove the screw securing the Auger at the rear of the printer.
14. Remove the screw and KL-Clip securing the Auger inside the printer (lower side).
15. Remove the screw securing the Auger inside the printer (upper side).
16. Free the harness from the clamp of the P/H Drive Assembly.
17. Remove the two screws securing the IBT Rear Bracket Assembly, and remove the IBT
Rear Bracket Assembly.
NOTE: After removing the Auger, place it on paper in case toner is spilled.
18. Remove the Auger (Figure 1).
Replacement
1. Reinstall the Auger in the reverse order of removal.
Figure 1 Removing the Auger
1
Remove the screws
securing the bracket
2
Remove the Auger
To Next Page
Loading...
Need help?
General
