10/00
4-88
Phaser 790/DocuColor 2006
REP 8.40
Initial Issue
Repairs and Adjustments
REP 8.40 Exit Transport Assembly
Parts List on PL 9.1
Removal
WARNING
To avoid personal injury or shock, do not perform repair activities with the power switch
on or electrical power applied to the machine.
1. Switch off the machine power and disconnect the machine Power Cord.
2. Remove the Top Cover. (REP 14.4)
3. Remove the Rear Cover. (REP 14.6)
CAUTION
The plastic hinges of the Transport Cover can be easily damaged. Use care when performing
the following step.
4. Remove the Exit Transport Cover. (Figure 1)
Figure 1 Removing the Transport Cover
5. Remove the Exit Transport Assembly. (Figure 2)
Figure 2 Removing the Exit Transport Assembly
Replacement
1. Perform the removal procedure in reverse.
2. When replacing the Exit Transport Assembly, make sure that the plastic ears at the top
(and at the bottom, below the fan) are positioned over the edge of the frame. (Figure 3)
Figure 3 Exit Transport Assembly Positioning
2
Remove the five
screws and the Exit
To Next Page
Loading...
Need help?
General
