10/00
4-99
Phaser 790/DocuColor 2006
REP 9.11
Repairs and Adjustments
Initial Issue
REP 9.11 Rotary Sensor
Parts List on PL 6.1
Removal
WARNING
To avoid personal injury or shock, do not perform repair activities with the power switch
on or electrical power applied to the machine.
1. Switch off the machine power and disconnect the machine Power Cord.
2. Remove the Rear Cover (REP 14.6).
3. Remove the Fan Duct and Fan in order to access the Rotary Sensor (Figure 1).
4. Remove the Rotary Sensor (Figure 2).
Figure 1 Removing the Fan Duct and Developer Frame
Replacement
1. Secure the harness so that the harness does not get caught in the gears.
2. Reinstall the Rotary Sensor in the reverse order of removal.
Figure 2 Removing the Rotary Sensor
1
Remove the
screw
2
Remove the Fan
Duct and Fan
together
1
Remove the
screw
2
Disconnect the sen-
sor connector
3
Unhook the tabs
and remove the
Rotary Sensor
To Next Page
Loading...
Need help?
General
