Mitsubishi GOT1000 Series User Manual

9.3 Preparatory Procedures for Monitoring
9.3.6 Verifying GOT recognizes connected equipment
9 - 33
9
CONNECTION TO OMRON PLC
10
CONNECTION TO KEYENCE PLC
11
CONNECTION TO SHARP PLC
12
CONNECTION TO TOSHIBA PLC
13
CONNECTION TO HITACHI PLC
14
CONNECTION TO MATSUSHITA PLC
15
CONNECTION TO YASKAWA PLC
16
CONNECTION TO YOKOGAWA PLC
9.3.6 Verifying GOT recognizes connected equipment
Verify the GOT recognizes connected equipments on [Communication setting] of the Utility.
• Channel number of communication interface, communication drivers allocation status
• Communication unit installation status
Remark
How to display Utility(at default),
When setting the utility call key to 1-point
When setting “Pressing Time” to other than 0 second on the setting screen of the
utility call key, press and hold the utility call key until the buzzer sounds.
For the setting of the utility call key, refer to the following.
GT15 User's Manual
When using GT1595-X
When using GT1585-S, GT1575-S,
GT1575-V, GT1575-VN, GT1572-VN,
GT1565-V, GT1562-VN or GT11
utility call key
utility call key
1-point press on GOT screen upper-left corner
Simultaneous 2-point press
(When using GT15)
Utility display

Mitsubishi GOT1000 Series Specifications

General

Brand	Mitsubishi
Model	GOT1000 Series
Category	Touch terminals
Language	English