Mitsubishi GOT1000 Series User Manual

19.6 Preparatory Procedures for Monitoring
19 - 73
17
CONNECTION TO ALLEN-BRADLEY PLC
18
CONNECTION TO SIEMENS PLC
19
MICROCOMPUTER CONNECTION
20
CONNECTION TO OMRON TEMPERATURE CONTROLLER
21
CONNECTION TO YAMATAKE TEMPERATURE CONTROLLER
22
CONNECTION TO RKC TEMPERATURE CONTROLLER
23
CONNECTION TO FREQROL SERIES INVERTER
24
SERVO AMPLIFIER CONNECTION
4
19.6 Preparatory Procedures for Monitoring
The following shows the procedures to be taken before monitoring and corresponding reference sections.
Install the OS onto the GOT.
Section 19.6.1
Installing OS onto GOT
Make sure that the OS is installed on the GOT.
Section 19.6.2
Checking OS installation on GOT
Set the communication interface.
(Communication settings)
Section 19.6.3
Setting communication interface
(Communication settings)
Download the project data.
Section 19.6.4
Downloading project data
Attach the communication unit and connect the cable.
Section 19.6.5
Attaching communication unit and
connecting cable
Make sure that the GOT recognizes the connected
equipment.
Section 19.6.6
Verifying GOT recognizes connected
equipment
Make sure that monitoring is performed normally.
Section 19.6.7
Checking for normal monitoring

Mitsubishi GOT1000 Series Specifications

General

Brand	Mitsubishi
Model	GOT1000 Series
Category	Touch terminals
Language	English