Mitsubishi GOT1000 Series User Manual

19.7 System Configuration Examples
19 - 87
17
CONNECTION TO ALLEN-BRADLEY PLC
18
CONNECTION TO SIEMENS PLC
19
MICROCOMPUTER CONNECTION
20
CONNECTION TO OMRON TEMPERATURE CONTROLLER
21
CONNECTION TO YAMATAKE TEMPERATURE CONTROLLER
22
CONNECTION TO RKC TEMPERATURE CONTROLLER
23
CONNECTION TO FREQROL SERIES INVERTER
24
SERVO AMPLIFIER CONNECTION
19.7 System Configuration Examples
The following shows a system configuration example in the case of the microcomputer connection.
1 System Configuration
The system configuration example illustrated below is explained in this section.
2 Communication settings on GOT side and monitor screen settings
(1) Transmission settings
Set the transmission settings of the GOT.
The transmission settings in the microcomputer connection are made at "Communication Details
Settings" on GT Designer2
Section 19.6.3 Setting communication interface (Communication settings)
(2) Monitor screen settings
The following shows the monitor screen settings in this system configuration example.
(a) Common settings
Set D20 to the screen switching device (base screen).
Setting item Setting
Transmission speed 38400bps
Data length 8 bits
Stop bit 1 bit
Parity Even
Interrupt Data Byte 1 byte
Host Address (0 to 31) 0
Format 1
1 Select [Common] [System Environment] on
GT Designer2, and display the [System
Environment].
2 Set D20 to the screen switching device (base
screen).
IBM-PC/AT-compatible PC
(Microsoft
®
Visual C++
®
Ver.6.0)

Mitsubishi GOT1000 Series Specifications

General

Brand	Mitsubishi
Model	GOT1000 Series
Category	Touch terminals
Language	English