#
To attachthe covers of themounting
shells: hold cover 3 suchthat retaininglug
1 is pointing towardsrear seat anchorage
2.
#
Insertcover 3 intorear seat anchorage 2
by pushing it downwardsatanangle and then
clip it to themounting shell.
#
Afterremoving therear benchseat, ensure
that therear benchseat can stand securely
and do nottip overwhen in storage.
Installing therear benchseat
Secureengagement of therear benchseat is
guaranteed only if youkeep theseat anchorages
clean and free of objects.
%
In vehicles registeredaspassenger vehicles,
observe themaximum permitted number of
seats.
#
Remove thecovers of themounting shells as
described under "Removing therear bench
seat".
#
Ensurethat thereare no objectsinthe seat
anchorages and mounting shells.
#
Position thebenchseat behind theinstalla‐
tion position.
#
Hold thebenchseat by thegrabhandles and
tilt it backwards.
#
Roll thebenchseat forwards on thelevel
plastic carriers.
#
Ensurethat therear legs of thebenchseat
areengaged.
#
Tilt thebenchseat forwards firmly until the
locks on thefront legs of thebenchseat
engageaudibly.
The locks on thefront legs of thebenchseat
will nowbelockedand thered indicator tabs
on thehousing of release handle 1 should
no longer be visible.
%
If thered indicator tabs on therelease handle
housing arevisible, thebenchseat is notcor‐
rectly engaged.
If thebenchseat is notcorrectlyengaged, you
can rectify this situation as follows:
#
Unlockthe benchseat again and tilt it for‐
wardsfirmlyuntil thelocks on thebenchseat
front legs engageaudibly.
#
Attach thecoversofthe mounting shells as
described under "Removing therear bench
seat".
Adjustingthe seat backrestofthe rear bench
seat
70
Seats and stowage
To Next Page
Loading...
Need help?
General
