5.2.2 Checklist prior to mounting
Description
The c
hecklist below is a minimum benchmark and must be performed in any case. Further
checks before, during, and after the installation of the motor depend on the system-specic
conditions and are the responsibility of the plant or system manufacturer.
Table 5-4 Checklist before installing
Check OK
General checks
Are the environmental conditions in the permissible range?
Checks regarding the mechanical system
Is the motor free of visible damage?
Have the mounting surfaces such as the ang
e and shaft on the customer machine and on the
motor been cleaned?
Are the mounting surfaces free of corrosion?
Do the mounting dimensions such as the shaft diameter, shaft length, and radial eccentricity
on t
he cust
omer machine meet the specications?
Mounting
5.2Motor
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
106 Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB
To Next Page
Loading...
Need help?
General
