Motor requirements As of the implementation date of the standard, all aected mo
tors must
be provided with the "China Energy Label".
Aected Siemens products Aected Siemens mo
tors are subject to the requirements of standard
GB30253-2013: SIMOTICS S-1FL2 servo motors.
Figure3-13 Example of the China Energy Label
The article number ① stat
ed on the China Energy Label corresponds to the rst 11 digits of
the article number of the SIMOTICS S-1FL2 motor.
Certicates for download
You can nd all relevant certicates for download on the Internet:
Certicates (https://support.industry.siemens.com/cs/ww/en/ps/29685/cert)
3.5.3 Directiv
es, standards and certicates for the MOTION-CONNECT cable
The following directives and standards are relevant for the MOTION-CONNECT cables:
European Low Voltage Directive
The MOTION-CONNECT cables fulll the requirements stipulated in the Low-Voltage Directive
2014/35/EU, if they are covered by the application area of this directive.
European Machinery Directive
The MOTION-CONNECT cables fulll the requirements stipulated in the Machinery Directive
2006/42/EC, if they are covered by the application area of this directive.
However, the use of the converters and motors in a typical machine application has been
fully assessed for compliance with the main regulations in this directive concerning health
and safety.
European RoHS Directive
The MOTION-CONNECT cables comply with Directive 2011/65/EU regarding limiting the use
of certain hazardous substances.
European EMC Directive
The compliance of the MOTION-CONNECT cables with the regulations of the Directive
2014/30/EU has been veried through full compliance with the IEC/EN 61800-3.
Description
3.5Directives and standards
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
76 Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB
To Next Page
Loading...
Need help?
General
