Siemens SINAMICS SIMOTICS S200 PROFINET User Manual

– Enter the drive password con󹪝gured in st
ep 2.
The drive password con󹪝gured in this step corresponds to the drive password with which
the drive data in the backup 󹪝le were encrypted.
A dialog to enter the password opens.
– Enter the drive password that was used to encrypt the drive data in the backup 󹪝le.
The drive data are loaded into the converter from the backup 󹪝le.
As a consequence, the status of the settings at the instant of the backup are restored.
Function "Drive data encryption" is activated. The originally con󹪝gured drive password is
applied.
7.4.6.6 Restore factory settings
Overview
The reset to factory settings with the web server deletes the user-speci󹪝c parameterization of the
converter, for example the motor data.
The following data are retained when the factory settings are restored:
• Communication interface settings
• Security settings (including UMAC)
• Language setting
• Date and time
In the following cases it may be necessary to restore the converter to factory settings:
• If the motor is changed
• If there is uncertainty regarding the previous parameterization and/or the previous use of the
converter
Requirement
If User Management & Access Control is activated, you will need the following function rights:
• Edit device con󹪝guration or drive applications
Procedure
1. Call the "Backup and restore" menu.
2. Click the "Restore factory settings" button.
3. Acknowledge the con󹪝rmation prompt.
The converter is reset and then restarted.
More information
For a full reset of the converter, proceed as described in Chapter "Reset of all user-de󹪝ned
settings to the factory setting via an SD card (Page587)".
Commissioning (web server)
7.4Functions and menus
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB 207

Siemens SINAMICS SIMOTICS S200 PROFINET Specifications

General

Brand	Siemens
Model	SINAMICS SIMOTICS S200 PROFINET
Category	Servo Drives
Language	English