Siemens SINAMICS SIMOTICS S200 PROFINET User Manual

1.5 Important product information
1.5.1 Intended use
R
equirement
WARNING
Death or serious injury if not used as intended
Not using as intended can r
esult in hazardous states.
• Carefully observe the description of intended use.
WARNING
Incorrect use of the motor
Incorrect
use of the motor may cause death, serious injury (crushing) and/or property damage.
• Carefully observe the description of intended use.
• Do not use the motors in hazardous areas (where there is a risk of explosion), if the motors
have not been expressly released and authorized for these types of applications. Carefully
observe any special supplementary notes that may be attached.
• Make sure that the conditions at the location of use comply with all the rating plate data.
• Make sure that the conditions at the location of use comply with the conditions speci󹪝ed in
this documentation. When necessary, take into account deviations regarding approvals or
country-speci󹪝c regulations.
Note
It cannot be guarant
eed that EMC emission limits are complied with if the products are
connected to an isolated line supply grounded through a high ohmic connection or a line supply
with grounded line conductor.
• Draw-up an EMC plan to comply with the EMC requirements of the intended application.
Description
The products
described in this manual, together with software, accessories and options, form an
electric drive to supply low-voltage AC motors.
The products are professional equipment for stationary indoor use in industrial, light-
industrial, and commercial applications and are intended for supply from non-public
(industrial) low-voltage line supplies. The products are not intended for use in residential
areas and are not intended for supply from public low-voltage networks.
The products must be properly transported and stored and must be installed, commissioned
and maintained by professionals who have adequate knowledge to implement the safety,
cybersecurity and EMC measures in accordance with the speci󹪝cations described in this
manual and with recognized state-of-the-art engineering practice.
Introduction
1.5Important product information
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB 21

Siemens SINAMICS SIMOTICS S200 PROFINET Specifications

General

Brand	Siemens
Model	SINAMICS SIMOTICS S200 PROFINET
Category	Servo Drives
Language	English