Siemens SINAMICS SIMOTICS S200 PROFINET User Manual

8.4.2 Simple basic parameterization (o󹪠ine)
Overvie
w
The following work󹪞ow represents the simplest form of commissioning.
Requirement
None
Procedure
Proceed as follows to perform basic parameterization in o󹪠ine mode:
1. Create or open a project with Startdrive.
2. Create device con󹪝guration in Startdrive o󹪠ine.
– Insert and specify the SINAMICS drive in the project.
– Optional: Con󹪝gure user management and make protection settings for the drive.
– Create and specify SINAMICS components.
– Make detailed settings for the drive and components.
3. Make basic settings o󹪠ine via the guided quick startup.
4. Load project data to the target device.
5. Establish an online connection between Startdrive and the target device.
6. Optimize commissioning.
Result
The motor rotates.
Commissioning (Startdrive)
8.4Procedures for device con󹪝guration and commissioning
SINAMICS S200 PR
OFINET servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB 231

Siemens SINAMICS SIMOTICS S200 PROFINET Specifications

General

Brand	Siemens
Model	SINAMICS SIMOTICS S200 PROFINET
Category	Servo Drives
Language	English