Siemens SINAMICS SIMOTICS S200 PROFINET User Manual

Requirement
• The drive has been completely created and speci󹪝ed in the device con󹪝guration.
• For activated user management (UMAC):
The function rights for con󹪝guring in the quick startup are activated for your user account.
Details on this topic are provided in Chapter "Security settings in Startdrive" of Industrial
Cybersecurity Con󹪝guration Manual (https://support.industry.siemens.com/cs/ww/en/view/
109810578).
Procedure
Pr
oceed as follows to download the project data to the device:
1. In the "Overview" function view, click "Download".
To transfer the protected project data, you must log into the device with your user data.
2. Proceed as described in Chapter "Loading project data into the drive (Page226)".
8.6.10.2 Online mode
Overview
After completing the commissioning steps in the guided quick startup, here, you will 󹪝nd a
compilation of all settings that were made online. You can sort and export the corresponding
information or also compare it with the factory settings.
Requirement
• The drive has been completely created and speci󹪝ed in the device con󹪝guration.
• There is an active online connection between the converter and the operating unit.
• The online con󹪝guration was completed.
• For activated user management (UMAC):
The function rights for con󹪝guring in the quick startup are activated for your user account.
Details on this topic are provided in Chapter "Security settings in Startdrive" of Industrial
Cybersecurity Con󹪝guration Manual (
https://support.industry.siemens.com/cs/ww/en/view/
109810578).
Procedure
Pr
oceed as follows to upload project data from the device:
1. After the online commissioning has been completed, if you want to transfer the current
project data into the TIA project of your operating unit, click "Finish".
is subsequently displayed in function view "Overview".
2. Clic
k
and proceed as described in the following chapter: "Loading data from the drive into
the project
(Page224)".
Commissioning (Startdrive)
8.6Carrying out guided quick startup
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB 275

Siemens SINAMICS SIMOTICS S200 PROFINET Specifications

General

Brand	Siemens
Model	SINAMICS SIMOTICS S200 PROFINET
Category	Servo Drives
Language	English