3.5 Directives and standards
3.5.1 Directiv
es, standards and certicates for the converter
The following directives and standards are relevant for the converter:
European Low Voltage Directive
The converter fullls the requirements stipulated in the Low-Voltage Directive 2014/35/EU, if
it is covered by the application area of this directive.
European Machinery Directive
The converter fullls the requirements stipulated in the Machinery Directive 2006/42/EC, if it
is covered by the application area of this directive.
However, the use of the converter in a typical machine application has been fully assessed for
compliance with the main regulations in this directive concerning health and safety.
European RoHS Directive
The converter complies with Directive 2011/65/EU regarding limiting the use of certain
hazardous substances.
European EMC Directive
The compliance of the converter with the regulations of the Directive 2014/30/EU has been
veried through full compliance with the IEC 61800-3.
European Directive on Waste Electrical and Electronic Equipment (WEEE)
The converter complies with the 2012/19/EU directive on taking back and recycling waste
electrical and electronic equipment.
Safety Integrated
The S200 PN converter complies with the requirements relating to functional safety/safety of
machinery.
Underwriters Laboratories (North American market)
The converters provided with the test symbol displayed fulll the requirements stipulated for
the North American market.
UKCA certication
The converter complies with the requirements for the market in Great Britain (England, Wales
and Scotland).
Australia and New Zealand (RCM formerly C-Tick)
The converter with the symbol displayed on the rating plate fullls the EMC requirements for
Australia and New Zealand.
Description
3.5Directives and standards
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB 73
To Next Page
Loading...
Need help?
General
