Siemens SINAMICS SIMOTICS S200 PROFINET User Manual

Result
The motor placeholder is assigned the data of the selected motor. The white area turns gray.
The motor has been added. The assigned encoder and the encoder evaluation are
automatically also added and speci󹪝ed.
You can then carry out the basic parameterization (Page276), or alternatively, you can carry
out the guided quick startup (Page253).
8.5.2 Control and technology object
8.5.2.1 Inserting a SIMATIC S7 controller into the project
Overview
If, in addition to the SINAMICS drive, you also wish to use a SIMATIC S7 controller in the device
con󹪝guration, then create an appropriate PLC in your project.
Note
Other control sy
stems
As an alternative to a SIMATIC S7 controller, a SINUMERIK ONE or a SINUMERIK MC can be used.
The procedure remains the same.
Requirement
• A new pr
oject has been created or an existing project is open.
• For activated user management (UMAC):
The function rights for editing drive and control system data are activated for your user
account.
Details on this topic are provided in Chapter "Security settings in Startdrive" of Industrial
Cybersecurity Con󹪝guration Manual (
https://support.industry.siemens.com/cs/ww/en/view/
109810578).
Commissioning (Startdrive)
8.5Combining and con󹪝guring devices in the pr
oject
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB 243

Siemens SINAMICS SIMOTICS S200 PROFINET Specifications

General

Brand	Siemens
Model	SINAMICS SIMOTICS S200 PROFINET
Category	Servo Drives
Language	English