TUNE–UP
ENGINE COOLANT INSPECTION
EG0EM–01
1. CHECK ENGINE COOLANT LEVEL AT RESERVOIR TANK
The engine coolant level should be between the ”LOW” and
”FULL” lines at low temperature.
If low, check for leaks and add engine coolant up to the
”FULL” line.
2. CHECK ENGINE COOLANT QUALITY
There should be no excessive deposits of rust or scales
around the radiator cap (water outlet side) or water outlet filter
hole, and the engine coolant should be free from oil.
If excessively dirty, replace the engine coolant.
ENGINE OIL INSPECTION
EG0EN–02
1. CHECK OIL QUALITY
Check the oil for deterioration, entry of water discoloring or
thinning.
If oil quality is poor, replace it.
Oil grade:
API grade SG Energy–Conserving II multigrade engine
oil.
Recommended viscosity is as shown.
2. CHECK ENGINE OIL LEVEL
The oil level should be between the ”L” and ”F” marks on the
dipstick.
If low, check for leakage and add oil up to the ”F” mark.
BATTERY INSPECTION
EG0EP–01
1. CHECK BATTERY SPECIFIC GRAVITY AND
ELECTROLYTE LEVEL
(a) Check the electrolyte level of each cell.
If insufficient, refill with distilled (or purified) water.
(b) Check the specific gravity of each cell.
–ENGINE TROUBLESHOOTING ENGINE MECHANICAL
EG–11
To Next Page
Loading...
Need help?
General
