3. REMOVE FUEL PUMP FILTER FROM FUEL PUMP
(a) Using a small screwdriver, remove the clip.
(b) Pull out the pump filter.
4. REMOVE CONNECTOR
Remove the two screws, connector support, connector and
gasket.
FUEL PUMP ASSEMBLY
EG0GJ–01
(See page EG–176)
1. INSTALL CONNECTOR
Install the gasket, connector and connector support with the
two screws.
2. INSTALL FUEL PUMP FILTER TO FUEL PUMP
Install the pump filter with a new clip.
3. INSTALL FUEL SENDER GAUGE TO FUEL PUMP
BRACKET
(a) Install the sender gauge with the two screws.
(b) Connect the fuel sender gauge connector.
4. INSTALL FUEL PUMP TO FUEL PUMP BRACKET
(a) Install the rubber cushion to the fuel pump.
(b) Connect the fuel hose to the outlet port of the fuel pump.
(c) Install the fuel pump by pushing the lower side of the fuel
pump.
(d) Install the fuel pump connector.
–ENGINE TROUBLESHOOTING SFI SYSTEM
EG–177
To Next Page
Loading...
Need help?
General
