34. REINSTALL EMISSION CONTROL VALVE SET
(a) Install the emission control valve set with the two bolts.
(b) Connect the two VSV connectors.
(c) Connect the two vacuum hoses of the IACV VSV.
(d) Connect the two vacuum hoses of the fuel pressure control
VSV.
(e) (Calif. only)
Connect the EGR gas temp. sensor connector clamp to the
emission control valve set.
35. REINSTALL V–BANK COVER
Using a 5 mm hexagon wrench, install the V–bank cover with
the two nuts.
36. INSTALL AIR CLEANER CAP, VOLUME AIR FLOW
METER AND AIR CLEANER HOSE
(a) Connect the air cleaner hose, and install the air cleaner cap
and volume air flow meter with the four clips.
(b) Tighten the air cleaner hose clamp bolt.
(c) Connect the air hoses.
(d) Connect the coil cord clamp.
(e) Connect the volume air flow meter connector.
37. (A/T)
CONNECT THROTTLE CABLE, AND ADJUST IT
38. CONNECT ACCELERATOR CABLE, AND ADJUST IT
39. FILL WITH ENGINE COOLANT
40. CONNECT CABLE TO NEGATIVE TERMINAL OF
BATTERY
–ENGINE TROUBLESHOOTING ENGINE MECHANICAL
EG–21
To Next Page
Loading...
Need help?
General
