1-1
SECTION 1
INTRODUCTION
TO THE PURCHASER
FOREWORD
This manual has been prepared to assist you in the
correct procedure for operation, adjustment and
maintenance of your new machine.
This machine has been designed and built to give
maximum performance, economy and ease of
operation under a wide variety of crops and
conditions.
Prior to delivery, your machine was carefully
inspected both at the factory and by your dealer to
ensure that it reaches you in optimum condition.
To maintain this condition and ensure trouble-free
operation it is important that routine services, as
specified in this manual, are carried out at the
recommended intervals.
You cannot operate or maintain your machine
properly without reading this manual attentively. Keep
it within reach.
Before attempting to drive or operate your machine,
read this manuel carefully (especially the chapter
covering the Safety Precautions).
‘‘Left’’ and ‘‘right’’ used throughout this manual are
determined from the rear, facing in the direction of
travel of the machine during operation.
If at any time you require advice concerning your
machine, do not hesitate to contact your authorised
dealer. He has factory-trained personnel, genuine
service parts and the necessary equipment to carry
out your service requirements.
IMPORTANT:
S This machine has been designed and built
according to the European Directive
EEC/89/392.
Always use genuine New Holland Service
Parts when servicing and repairing your
machine and do not modify your machine
without a written permission of the
manufacturer . Failure to do so will void the
responsibility of the manufacturer.
S An EC Declaration of Confirmity is
separately delivered with your machine.
Store this EC Declaration into the storage
space for your Operator’s Manual (Refer to
Section 2 - OPERATION).
S The maximum road speed of your combine
is limited and sealed. Do not remove the
seal.
S Check local road legislation before driving
the combine on public roads.
S When operating interchangeable New
Holland built equipment, ensure the
equipment is CE approved.
S As this publication is distributed throughout
our international network, the equipment
illustrated, either as standard or as an
accessory, may vary according to the
country in which the equipment is to be
used. Low cost configurations, as chosen
by the customer, may deviate from the
specifications given.
To Next Page
Loading...
Need help?
General
