SECTION 1
1-27
ELECTROMAGNETIC COMPATIBILITY (EMC)
This product complies with the EEC directive 89/336
on Electromagnetic Interferences on electronic
equipment if it is used in conjunction with equipment
which bears the CE mark.
New Holland will take no liability for any problem
arising as a result of its product working in an
environment of other equipment which does not
comply with the EEC directive.
Disturbances remain possible if added equipment
does not meet the standards. As these interferences
may result in serious malfunction of the machine
and/or create unsafe situations the following
instructions must be observed:
S Each element of non New Holland equipment
ad-ded to this New Holland product must bear a
CE mark.
S The maximum power of emission equipment
(radio, telephones, etc.) must not exceed the
limits imposed by the national authorities of the
country of usage of the machine.
S The electromagnetic field generated by the added
system must not exceed 24 V/m at any moment
and at any location in the proximity of electronic
components and the network between them over
the entire machine.
SAFETY REQUIREMENTS FOR FLUID POWER SYSTEMS AND
COMPONENTS -- HYDRAULICS
(European standard pr EM 982)
Flexible hose assemblies must not be constructed
from hoses which have been previously used as part
of a hose assembly.
Do not weld hydraulic piping.
When flexible hoses or piping are damaged, replace
them immediately.
It is forbidden to modify a hydraulic accumulator by
machining, welding or any other means.
Before removing hydraulic accumulators for
servicing, the liquid pressure in the accumulator must
be reduced to zero.
Pressure check on hydraulic accumulators shall be
carried out by method recommended by the
accumulator manufacturer.
Care must be taken not to exceed the maximum
allowable pressure of the accumulator. After any
check of adjustment there must be no leakage of gas.
To Next Page
Loading...
Need help?
General
