SECTION 4
4-103
c) Figure 157 - Appearing:
‘‘CALIBRATE RETURN: YES / SET
THRESHING ON / SET ENGINE SPEED
MAX / RETURNS AUGER MUST BE EMPTY
/ PRESS ENTER ’’.
This means, to calibrate the returns:
S The threshing mechanism must be en-
gaged.
S The engine must be run on maximum.
S The returns auger must be empty.
Press
to confirm this.
d) Figure 157 - Appearing:
‘‘CAL/SET COMPLETE’’ at the bottom of the
display.
This means line 4 is now calibrated. After 5
seconds the monitor returns to the rpm mode
(Figure 84).
Line 5 -- DATE & TIME
The date and time is needed when memorizing data
or when errors are shown.
Changing can be needed:
S When changing from summer to winter time,
or vice versa
S After carrying out repairs
1. Enter the calibration mode by pressing
.
2. Select line 5 (‘‘DATE & TIME’’) by pressing
or , and to validate the
choice.
48145
48146
157
158
To Next Page
Loading...
Need help?
General
