SECTION 6
6-9
CONCERN POSSIBLE CAUSE CORRECTION PAGE
Engine starts, then
stops.
Air in fuel system. Bleed fuel system. 5-43
Fuel filters restricted. Replace filters. 5-43
Insufficient oil pressure. Insufficient oil. Add oil. 3-14
Sender unit defective. Replace sender unit. --
Oil pressure gauge defective. Replace oil pressure gauge. --
Engine will not idle. Air in fuel system. Bleed fuel system. 5-43
STRAW CHOPPER
CONCERN POSSIBLE CAUSE CORRECTION PAGE
Chopper vibrates during
operation.
Rotor knife damaged or broken. Replace damaged or broken rotor
knife.
4-109
Rotor bearing broken. Contact your local dealer. --
Rotor out of balance. Ensure all knives are swinging
freely, are undamaged and
equally worn. Clean rotor prop-
erly.
--
Poor chop quality, i.e. too
long.
Damaged knife or knives on rotor
and counter knives bar.
Replace damaged knives and
sharpen counter knives.
4-110
Dull rotor knives and counter
knives.
T urn, or replace, rotor knives.
Sharpen or replace counter
knives.
4-109
Incorrect rotor speed. Rotor speed must be 3500 rpm
minimum (on standard speed).
Check belt tensions.
5-7
To Next Page
Loading...
Need help?
General
