LUBRICATION
3-16
Filter change -- Figures 65 and 66
The oil filters should be changed every time the oil is
changed.
Access is gained through the grain tank.
Proceed as follows:
1. Remove the ‘‘spin-on” filter(s) M.
2. Fill up the new filters with oil and apply a film of oil
to the seal ring.
3. Screw on the filters by hand. Tighten firmly but DO
NOT USE TOOLS!
4. Renew the engine oil. Refer to the paragraph
headed ‘‘Recommended oil and filter change in-
tervals’’.
5. Start the engine and check the oil filters for leaks.
CHAINS, THREADED RODS AND PIVOT POINTS
Chains
Lubricate the following chains DAILY AND IMMEDI-
ATELY AFTER WORK.
In this way the oil will penetrate into the chains and
provide excellent protection and lubrication. Use a
special (biodegradable) chain oil or an SAE 90 gear
oil. (Belt and chain charts are included in Section 5 -
ADJUSTMENTS AND MAINTENANCE).
S Returns auger drive
S Grain elevator drive
S Unloading auger drive
55013
65
TX68-68
PLUS
66
52732
To Next Page
Loading...
Need help?
General
