Canon IR1600 - Checking the Printer Functions; Functions)

CHAPTER 11 INSTALLATION
COPYRIGHT © 2002 CANON INC. 2000 CANON iR1600/iR2000 REV.1 JAN. 2002
11-24
2.13 Checking the Printer Functions (if equipped with printer
functions)
1) Turn on the machine.
2) Press the System key in the control panel, and check to see that the LED of the key has
gone ON. (‘READY’ will be indicated on the display; otherwise, check to be sure that
the printer board has been mounted properly.)
3) Execute the ’TEST PRINT’ as follows to make sure that printing is normal:
1. Press the System key in the control panel (so that the LED of the key goes ON).
2. Press the GO key so that the machine will be in off-line state. (‘PAUSE’ will be indi-
cated on the display.)
3. Press the menu key. (‘TEST MENU’ will be indicated on the display.)
4. Select ‘TEST PRINT’ using the Item key, and press the Enter key to start test print-
ing.
4) Check to see that the name and the version of the printer board are indicated on the gen-
erated test print.
5) Turn off the machine, and connect the network cable.
6) Turn on the machine.
7) Inform the user’s system administrator that the machine has been installed, and ask him/
her to make network settings.