COPYRIGHT
©
2002 CANON INC. 2001 2001 2001 2001 CANON Printer Board-N1/iN-E5 REV.0 JAN. 2002
5-6
CHAPTER 5 TROUBLESHOOTING
2.3 Normal Error
A normal error indication may be any of the following; take the action given to suit
each indication:
Message
AUTHENTICATION
ERROR
EXCEEDS STORE
LIMIT
PS OPTION ERROR
OPTION RAM ERROR
OPTION ROM ERROR
FLASH ERROR
WRITING DISK ERROR
READING DISK ERROR
MEM ALLOC ERROR
Meaning
Invalid password
Unable to save a print job on the
printer hard disk.
An option PS module error oc-
curred.
An option RAM error occurred.
An option ROM error occurred.
The Flash ROM error occurred.
Unable to write to the printer
hard disk.
Unable to read the printer hard
disk.
Not enough memory to process
the data and print the page.
Action
Enter the correct password.
There is not enough available free space
on the hard disk. Delete unnecessary
print jobs from the hard disk, and then,
press the Go key on the printer.
An option ROM has failed the startup
checksum. Replace the option ROM.
An option RAM has failed the startup
diagnostic. Replace the option RAM.
An option ROM has failed the startup
checksum. Replace the option ROM.
Replace the Flash ROM.
Make sure that the hard disk is installed
correctly.
Turn off the printer, and the turn it on
again.
If the warning persists, format the hard
disk.
Make sure that the hard disk is installed
correctly.
Turn off the printer, and then turn it on
again.
If the warning persists, format the hard
disk.
If AUTOCONT is ON (CONFIG
MENU), the printer will be put back
online after 10 sec.
If AUTOCONT is OFF, press the GO
key to put the printer back online.
Check the printed page to ensure that
the print job is complete.
To Next Page
Loading...
Need help?
General
