Commands Listed in Alphabetical Order
Syntax
CH<x>:DESKew <
NR3>
CH<x>:DESKew?
Arguments
<NR3> is the deskew time for this channel, ranging from -25 ns to +25 ns with a
resolution of 1 ps. Out-of-range v alues are clipped.
Examples
CH4:DESKEW 5.0E-9 sets the deskew time for Channel 4 to 5 ns.
CH2:DESKEW? might return :CH2:DESKEW 2.0000E-09, indicating that the
deskew time for Channel 2 is set to 2 ns.
CH<x>:LABel:NAMe
This command sets or queries the l abel attached to the displayed waveform for the
specified channel. The channel is specified by x. The value of x can range from 1
through 4. This command is equivalent to selecting Label from the Vertical menu.
Group
Vertical
Syntax
CH<x>:LABel:NAMe <str>
CH<x>:LABel:NAMe?
Arguments
<str> is an alphanumeric character string, ranging from 1 through 32 characters
in length.
Examples
CH2:LABEL:NAMe "Pressure" changes the waveform label for the Channel 2
waveform to “Pressure”.
CH3:LABEL:NAMe? might return :CH3:LABEL: NAME "Force", indicating
that the waveform label for the Channel 3 waveform is “Force”.
CH<x>:LABel:XPOS
This command sets or queries the X screen offset at which the label (attached to
the displayed waveform of the specified channel) is displayed, relative to the left
edge of the screen. The channel is specified by x. The value of x can range from 1
through 4. This command is equivalent to selecting Label from the Vertical menu
and either viewing or setting X Pos.
Group
Vertical
2-112 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual
To Next Page
Loading...
Need help?
General
