Commands Listed in Alphabetical Order
TRIGger:A:PU
Lse:WINdow:POLarity:CH<x>
This command sets or queries the pulse trigger window polarity of the specified
channel. The oscilloscope triggers only when the signal exits the window. This
command is av
ailable only when the Window Event is set to Inside > t and not
available for the rest of the window events. The logic selection is available only
when the p olarity is set to Either. <x> is the search number or channel number.
Group
Trigger
Syntax
TRIGger:A:PULse:WINdow:PO Larity:CH<x>
{EITher|NEGAtive|POSITIVe }
TRIGger:A:PULse:WINdow:PO Larity:CH<x>?
Arguments
EITher specifi es positive or negative polarity.
NEGAtive specifies a negative polarity.
POSITIVe specifies a positive polarity.
Examples
TRIGGER:A:PULSE:WINDOW:PO LARITY:CH<x> POSITIVE sets the window
polarity to positive.
TRIGGER:A:PULSE:WINDOW:PO LARITY:CH<x>? might return
:TRIGGER:A:PULSE:WINDOW:P OLARITY:CH<x> EITHER, indicating that t
he
window polarity is either positive or negative.
TRIGger:A:RS232:BAUd
DPO7000 Series only: This command sets or queries the baud rate for RS232
triggering.
Group
Low Speed Serial Trigger
Syntax
TRIGger:A:RS232:BAUd <x>
TRIGger:A:RS232:BAUd?
Arguments
Xspecifies the baud rate for RS232 triggering. X can be: 1500000, 921600.
750000, 460800, 115200, 57600, 38400, 19200, 9600, 7200, 4800, 2400, 2000,
1800, 1200, 600, 300, 150, or 75.
2-576 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual
To Next Page
Loading...
Need help?
General
