Tektronix DPO70000 Series Programmer's Manual

Commands Listed in Alphabetical Order
Examples
WFMINPRE:YMUL
T 20E-3
specifies that (if WFMInpre:YUNit is “V”
and WFMInpre:BYT_Nr is 1), the vertical scale is 20 mV/digitizing level
(500 mV/div).
WFMINPRE:YMULT? might return :WFMINPRE:YMU LT 40.0000E-3, indicating
that the vertical scale is 40 mV/digitizing level (1V/div).
WFMInpre:Y
OFf
This command sets or queries the vertical position of the incoming waveform in
digitizing levels. Variations in this number are analogous to changing the vertical
position
of the waveform. For those formats in w hich WFMInpre:BYT_Nr is
important (all non-floating point formats), this command must take the location of
the b inary point implied by BYT_NR into consideration.
Group
Waveform Transfer
Syntax
WFMInpre:YOFf <NR3>
WFMInpre:YOFf?
Related Commands
WFMInpre:BYT_Nr, WFMInpre:YMUlt, WFMOutpre:YOFf?
Arguments
<NR3> is the vertical offset in digitizing levels.
Examples
WFMINPRE:YOFF 50 specifies that the zero reference point for the incoming
waveform is 50 digitizing levels (2 divisions) above the center of the data range.
WFMINPRE:YOFF? might return :WFMINP RE:YOFF 25, indicating the vertical
position o f the incoming waveform in digitizing levels.
WFMInpre:YUNit
This command sets or queries the vertical units of the incoming waveform.
Group
Waveform Transfer
Syntax
WFMInpre:YUNit <QString>
WFMInpre:YUNit?
Related Commands
WFMOutpre:YUNit?
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-637

Tektronix DPO70000 Series Specifications

General

Brand	Tektronix
Model	DPO70000 Series
Category	Test Equipment
Language	English