Appendix C: Factory Default Setup Values
Default Setup
The following tables list the default setup values by command group. The
instrument sets these values when you press the front p
anel DEFAULT SETUP
button or send the FACtory command. Only those commands that have values set
by the DEFAULT SETUP function are listed in these tables.
NOTE. The following commands do not affect the DATa parameters: TEKSecure,
*RST, RECALL:SETUP FACtory. These are the initial factory default settings for
DATa :DATA:DESTINATION REF1;ENCDG RIBINARY;SOURCE CH1;START
1;STOP 5000;FRAMESTART 1;FRAMESTOP 5000.
NOTE. Find the most up-to-date values for your instrument and software by
pressing default setup and looking at the instrument to get the default values.
Acquisition Default Values
The following table lists the Acquisition f actory default setup values.
Command Default Values
ACQuire:MODe SAMPLE
ACQuire:NUMAVg
16
ACQuire:NUMEnv
10
ACQuire:NUMSAMples
16000
ACQuire:SAMPlingmode
IT
ACQuire:STATE 1(ON)
ACQuire:STOPA fter RUNSTOP
FA STAcq:STATE
0
Alias D efault Values
The following table lists the Alias factory default setup values.
Command Default Values
ALIas:STATE 0(OFF)
Cursor Default Values
The following table lists the C ursor factory de fault setup values.
Command Default Values
CURSor:FUNCtion VBARS
CURSor:HBArs:POSITION<x>
1 = 300.0000E-3
2 = -300.0000E-3
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual C-1
To Next Page
Loading...
Need help?
General
