Commands Listed in Alphabetical Order
Group
Trigger
Syntax
TRIGger:A:MODe {AUTO|NORMal}
TRIGger:A:MODe?
Related Commands
TRIGger:{A|B}:LEVel
Arguments
AUTO generates a trigger if one is not detected within a specified time period.
NORMal waits for a valid trigger event.
Examples
TRIGGER:A:MODE NORMAL sets the trigger mode to normal.
TRIGGER:A:MODE? might return :TRIGGER:A:MODE AUTO, indicating that
the trigger mode is auto.
TRIGger:A:PULse:WINdow:POLarity
This command sets or queries the pulse trigger window polarity of the selected
trigger Source. The instrument triggers when the signal exits the window. This
command is available only when the Window Event is set to Inside > t and not
available for the rest of the window events. The logic selection is available only
when the polarity is set to Either.
Group
Trigger
Syntax
TRIGger:A:PULse:WINdow:POL arity {EITher|NEGAtive|PO SITIVe}
TRIGger:A:PULse:WINdow:POL arity?
Arguments
EITher specifies positive or negative polarity.
NEGAtive specifies a negative polarity.
POSITIVe specifies a positive polarity.
Examples
TRIGGER:A:PULSE:WINDOW:POL ARITY PO SITIVE sets the window polarity to
positive.
TRIGGER:A:PULSE:WINDOW:POL ARITY? might return
:TRIGGER:A:PULSE:WINDOW:PO LARITY EITHER, indicating that
the window polarity is either positive or negative.
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-575
To Next Page
Loading...
Need help?
General
