Tektronix DPO70000 Series Programmer's Manual

Commands Listed in Alphabetical Order
Syntax
SEARCH:SEARCH
<x>:TRIGger:A:SETHold:HOLDTi me <NR3>
SEARCH:SEARCH<x>:TRIGger:A :SETHold:HOLDTime?
Arguments
<NR3> specifies the hold time setting in seconds. Positive values for hold time
occur after the clock edge. Negative v alues occur before the clock edge.
Examples
SEARCH:SEARCH1:TRIGGER:A:S ETHOLD:HOLDTIME? 400E-12 sets the
setup/hold trigger hold time setting for search 1 to 400 ps.
SEARCH:SEARCH1:TRIGGER:A:S ETHOLD:HOLDTIME? might return
:SEARCH:SEARCH1:TRIGGER:A: SETHOLD:HOLDTIME 500.0000 E–12,
indicating that the setup/hold trigger hold time setting for search 1 is set to 0.5 ns.
SEARCH:SEARCH<x>:TRIGger:A:SETHold:SETTime
This command sets o r queries the setup time setting for a setup/hold trigger search
to determine where to place a mark. <x> is the search number.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :SETHold:SETTime <NR3>
SEARCH:SEARCH<x>:TRIGger:A :SETHold:SETTime?
Arguments
<NR3> specifies the setup time for setup and hold violation triggering.
Examples
SEARCH:SEARCH1:TRIGGER:A:S ETHOLD:SETTIME 2E–9 sets the s
etup/hold
trigger setup time setting for search 1 to 2 ns.
SEARCH:SEARCH1:TRIGGER:A:S ETHOLD:SETTIME? might return
:SEARCH:SEARCH1:TRIGGER:A: SETHOLD:SETTIME 1.0000E–9, indicating
that the setup/hold trigger setup time setting for search 1 is set to 1.0 ns.
SEARCH:SEARCH<x>:TRIGger:A:STATE:CLOCk:EDGE
This command sets or queries the clock slope setting for a state trigger search to
determine where to place a mark. <x> is the search number.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :STATE:CLOCk:EDGE {FALL|R ISe}
SEARCH:SEARCH<x>:TRIGger:A :STATE:CLOCk:EDGE?
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-467

Tektronix DPO70000 Series Specifications

General

Brand	Tektronix
Model	DPO70000 Series
Category	Test Equipment
Language	English