Tektronix DPO70000 Series Programmer's Manual

Commands Listed in Alphabetical Order
Syntax
CURSor:XY:THD
ELta?
Examples
CURSOR:XY:THDELTA? might return :CURSOR:XY:THDELTA 136.3748,
indicating that the Dq XY cursor angle is 136.3748 degrees.
CURSor:XY:THETA<x>? (Query Only)
This query-only command returns the XY cursor angle in polar coordinates. The
cursor is specified by x, which can be 1 or 2.
NOTE. This query is only valid when the CURSor:XY:READOUT is set to
POLARCoord. If the readout is set other than polar coordinates, the IEEE
representation of NAN (Not a Number) is returned: 99.1000E+36.
Group
Cursor
Syntax
CURSor:XY:THETA<x>?
Examples
CURSor:XY:THETA2? might return :CURSOR:XY:THETA2 -89.0906,
indicating that the Channel 2 XY cursor angle in polar coordinates is -89.0906
degrees.
CURSor:XY:XDELta? (Query Only)
This query-only command returns the XY cursor X delta value in rectangular
coordinates.
NOTE. This query is only valid when the CURSor:XY:READOUT is set to
RECTangular. If the readout is set to other than rectangular coordinates, the
IEEE representation of NAN (Not a Number) is returned: 99.1000E+36.
Group
Cursor
Syntax
CURSor:XY:XDELta?
Examples
CURSOR:XY:XDELTA? might return :CURSOR:XY:XDELTA 40.0000E-3,
indicating that the DX value is 40 mV.
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-149

Tektronix DPO70000 Series Specifications

General

Brand	Tektronix
Model	DPO70000 Series
Category	Test Equipment
Language	English