Commands Listed in Alphabetical Order
Syntax
ACQuire:NUMAC
q?
Related Commands
ACQuire:STATE
Examples
ACQUIRE:NUMACQ? might return :ACQUI RE:NUMACQ 350, indicating that 350
acquisitions have occurred since executing an ACQuire:STATE RUN command.
ACQuire:NUMAVg
This command sets or queries the number of waveform acquisitions that make up
an averaged waveform. Use the ACQuire:MODe command to enable the Average
mode. Sending this command is equivalent to selecting Horizontal/Acquisition
Setup from the Horiz/Acq menu, selecting the Acquisition tab, and choosing
Average from the Acquisition Mode group box. Then enter the desired number
of waveforms that will be used to make up an averaged waveform in the # of
Wfms box.
Group
Acquisition
Syntax
ACQuire:NUMAVg <NR1>
ACQuire:NUMAVg?
Related Commands
ACQuire:MODe
Arguments
NR1 is the number of waveform acquisitions to average.
Examples
ACQUIRE:NUMAVG 10 specifies that 10 waveform averages will be performed
before exponential averaging starts.
ACQUIRE:NUMAVG? might return :ACQU IRE:NUMAVG 75, indicating that there
are 75 acquisitions specified for a veraging.
ACQuire:NUMEnv
This command sets o r queries the number of waveform acquisitions that make
up an envelope waveform. Sending this command is equivalent to setting the #
of Wfms in the Acquisition Setup menu when Envelope Acquisition mode is
selected.
2-78 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual
To Next Page
Loading...
Need help?
General
