Tektronix DPO70000 Series Programmer's Manual

Commands Listed in Alphabetical Order
MATH<x>:FILT
er:RISetime
This command or query sets or returns the filter rise time parameter.
Group
Math
Syntax
MATH<x>:FILTer:RISetime <nr3>
MATH<x>:FILTer:RISetime?
Arguments
<nr3> sets how the filter affects a signal. The bandwidth of the filter is
approximately 0.35 / (filter rise time). For a square wave input, the measurement
system rise time of Math(x) = filter (chx) is very close to the filter rise time of
Math(x).
Examples
MATH1:FILTER:RISETIME 1.7e-3 sets the filter rise time to 1.7 milliseconds.
MATH1:FILTER:RISETIME? might return
:MATH1:FILTER:RISETIME 1.0000E-9, indicating that the filter rise time
parameter is set to 1 nanoseconds for Math 1 waveform.
MATH<x>:LABel:NAMe
This command sets or returns the label string, which is used for annotating the
math waveform on the screen. The math waveform to which the l abel is attached
is specified by x, which ranges in value from 1 through 4. This command is
equivalent to selecting Math Setup from the Math menu and entering a label
in the Label box.
Group
Math
Syntax
MATH<x>:LABel:NAMe <string>
MATH<x>:LABel:NAMe?
Arguments
<string> specifies the label to annotate the math waveform.
Examples
MATH2:LABEL:NAME "PROBE POINT7" assigns “Probe point7” Ma
th 2
waveform.
MATH2:LABEL:NAME? might return :MA TH2:LABEL:NAME "Prob
e point7 "
,
indicating that Probe point 7 is the label for Math 2 waveform.
2-348 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual

Tektronix DPO70000 Series Specifications

General

Brand	Tektronix
Model	DPO70000 Series
Category	Test Equipment
Language	English