Tektronix DPO70000 Series Programmer's Manual

Commands Listed in Alphabetical Order
WFMOutpre:PT
_ORder? (Query Only)
This query-only command specifies whether the source waveform is Fast
Acquisition. A Fast Acquisition waveform is stored as a 502 (vertical) by
1000 (horizo
ntal) point bitmap. Each point represents display intensity f or that
screen location. Only CURVe? query functions are allowed on Fast Acquisition
waveforms.
When the WFMOutpre:PT_OR query returns Column, this indicates that
the source is a Fast Acquisition waveform (and that each of 1000 possible
horizontal columns being transmitted contains 502 vertical points). When the
WFMOutpre:PT_OR? query returns Linear, this indicates that the source is
not a Fast Acquisition waveform (and that each horizontal column being sent
contain
s only one vertical point). Note that waveform points are transmitted in
the following order: top to bottom, then left to right.
Group
Waveform Transfer
Syntax
WFMOutpre:PT_ORder?
Related Commands
DATa:SOUrce
Examples
WFMOUTPRE:PT_ORDER? might return :WFMOUTPRE:PT_OR CO L specifying that
the waveform designated by the DATa:SOUrce waveform is a Fast Acquisition
waveform.
WFMOUTPRE:PT_ORDER? might return :WFMOUTPRE:PT_OR L INEAR, indicating
that the source waveform is a non-Fast Acquisition waveform.
WFMOutpre:WFId? (Quer y Only)
This query-only command returns a string describing several as pects of the
acquisition parameters for the waveform specified by the DATa:SOUrce command.
An error is reported if the DATa:SOUrce waveform does not exist.
Group
Waveform Transfer
Syntax
WFMOutpre:WFId?
Related Commands
DATa:SOUrce
2-644 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual

Tektronix DPO70000 Series Specifications

General

Brand	Tektronix
Model	DPO70000 Series
Category	Test Equipment
Language	English