Tektronix DPO70000 Series Programmer's Manual

Commands Listed in Alphabetical Order
Examples
SEARCH:SEARCH
1:TRIGGER:A:EDGE:SLOPE:REF2 RISE
sets the Reference 2
waveformslopeforsearch1torise.
SEARCH:SEARCH1:TRIGGER:A: EDGE:SLOPE:REF1? might return
:SEARCH:SEARCH1:TRIGGER:A :EDGE:SLOPE:REF1 FALL, indicating that the
slope for the Reference 1 waveform trigger for search 1 is the falling edge.
SEARCH:SEARCH<x>:TRIGger:A:EDGE:SOUrce
This command sets or queries the source waveform for an edge trigger search to
determine where to place a mark. <x> is the search number.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:EDGE:SOUrce
{CH1|CH2|CH3|CH4|MATH1|MA TH2|MATH3|MATH4|REF1|REF2|REF3|REF4}
SEARCH:SEARCH<x>:TRIGger: A:EDGE:SOUrce?
Arguments
CH<x> specifies one input channel as the edge source, where <x> is the channel
number.
MATH<x> specifies the math waveform as the search source, where <x> = 1, 2, 3
or 4.
REF<x> specifies the reference waveform as the se arch source, where <x> =
1, 2, 3 or 4.
Examples
SEARCH:SEARCH1:TRIGGER:A: EDGE:SOURCE CH2 sets the source waveform
for the A trigger to Channel 2.
SEARCH:SEARCH1:TRIGGER:A: EDGE:SOURCE? might return
:SEARCH:SEARCH1:TRIGGER:A :EDGE:SOURCE CH2, indicating that the
Channel 2 edge trigger is the source for search 1.
SEARCH:SEARCH<x>:TRIGger:A:GLItch:POLarity:CH<x>
This command sets or queries the polarity for a glitch trigger search to determine
where to place a mark. <x> is the search number or channel number.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:GLItch:POLarity:CH<x>
{EITher|NEGAtive|POSITIVe }
2-444 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual

Tektronix DPO70000 Series Specifications

General

Brand	Tektronix
Model	DPO70000 Series
Category	Test Equipment
Language	English