Commands Listed in Alphabetical Order
Arguments
ON turns on the p
ass/fail mask:test:aux on completion.
OFF turns off the pass/fail mask:test:aux on completion.
<NR1> = 0 disables the m ask:test:aux:completion function; any other value
enables it.
Examples
MASK:TEST:AUX:COMPLETION ON turns on the pass/fail test on completion.
MASK:TEST:AUX:COMPLETION? might return :MASK: TEST:AUX:COMPLETION
ON
, indicating that the test:aux on pass/fail test completion mode is turned on.
MASK:TESt:AUX:FAILure
This command sets or returns the test:aux status on pass/fail test failure mode.
When enabled, this command causes the instrument to provide a TTL signal at the
AuxOut port when the pass/fail status changes to ‘Failing’.
Group
Mask
Syntax
MASK:TESt:AUX:FAILure {OFF|ON|<NR1> }
MASK:TESt:AUX:FAILure?
Arguments
ON turns on the pass/fail mask:test:aux on failure.
OFF turns off the pass/fail mask:test:aux on failure. This is the default.
<NR1> = 0 disables the mask:test:aux:failure function; any other value enables it.
Examples
MASK:TEST:AUX:FAILURE ON turns on the pass/fail test on failure.
MASK:TEST:AUX:FAILURE? might return :MASK:TES T:AUX:FAILURE ON,
indicating that the pass/fail mask :test:aux on failure is turned on.
MASK:TESt:BEEP:COMPLetion
This command sets or returns the beep on pass/fail test completion mode. When
enabled, this command causes the in strument to emit a tone when the mask
pass/failtestcompletes.
Group
Mask
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-325
To Next Page
Loading...
Need help?
General
