Commands Listed in Alphabetical Order
DISplay:PERS
istence
This command se ts or queries the persistence aspect of the display. This affects
the display only and is equivalent to selecting Display Persistence from the
Display menu
.
Group
Display Control
Syntax
DISplay:PERSistence {OFF|INFPersist |VARpersist}
DISplay:PERSistence?
Related Commands
DISplay:VARpersist
Arguments
OFF disables the persistence aspect of the display.
INFPersist sets a display mode where any pixels, once touched by samples,
remain set until cleared by a mode change.
VARPersist sets a display mode where set pixels are gradually dimmed.
Examples
DISPLAY:PERSISTENCE VARPERSIST sets the pers i stence aspect of the display
to fade set pixels according to the time set in the DISplay:VARpersist command.
DISPLAY:PERSISTENCE? might return :D ISPLAY:PERSISTE NCE OFF,
indicating that the persistence aspect of the display is disabled.
DISplay:PERSistence:RESET (No Query Form)
This query-only command controls the clearing of persistence data.
Group
Display Control
Syntax
DISplay:PERSistence:RESET
Related Commands
DISplay:PERSistence, DISplay:VARpersist
Examples
DISPLAY:PERSISTENCE:RESET clears the display of persistence data.
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-191
To Next Page
Loading...
Need help?
General
