Commands Listed in Alphabetical Order
Group
E-mail
Syntax
EMail:MEASUrement {ON|OFF|<NR1>}
EMail:MEASUrement?
Arguments
ON enables the inclusion of measurement data in e-mail.
OFF disables the inclusion of measurement data in e-mail.
<NR1> = 0 disables the inclusion of measurement data in the e-mail; any other
value enables including measurement data in the e-mail.
Examples
EMAIL:MEASUREMENT 1 enables the inclusion of measurement data in e-mail.
EMAIL:MEASUREMENT? might return :EM AIL:MEASUREMENT 0, indicating that
measurement data is not included in the e-mail.
EMail:NUMEMails
This
command sets or queries the number o f e-mails you can send when Email on
Event is armed, from 1 to 50. This limit is to restrict e-mail floods.
Group
E-mail
Syntax
EMail:NUMEMails {<NR1>}
EMail:NUMEMails?
Related Commands
EMail
Arguments
<NR1> can be 1 through 50. This is the number of e-mails you can send before the
number of sent e-mails must be reset with the EMail RESet command.
Examples
EMAIL:NUMEMAILS 10 sets the n umber of e -mails that can be sent to 10.
EMAIL:NUMEMAILS? might return :EMAI L:NUMEMAILS 5, indicating that five
e-mails can be sent.
EMail:SMTPPort
This command sets or queries the SMTP port number that the e-mail server uses if
other than the default of 25.
2-206 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual
To Next Page
Loading...
Need help?
General
