Tektronix DPO70000 Series Programmer's Manual

Commands Listed in Alphabetical Order
Group
Cursor
Syntax
CURSor:XY:RATDELta?
Examples
CURSOR:XY:RATDELTA? might return :CURSOR:XY:RATDEL TA -1.0167,
indicating that the ΔY/ΔX ratio is -1.0167.
CURSor:XY:RATIO<x>? (Query Only)
This query-only command returns ratio the of the X (horizontal) and Y (vertical)
position for the specified cursor when the CURSor:XY:READOUT is set to
RATio. The cursor is specified by x, which can be 1 or 2. The ratio is calculated
as Y ÷ X.
NOTE. This query is only valid when the CURSor:XY:READOUT is set to RATio.
If the readout is set other than ratio, the IEEE representation of NAN (Not a
Number) is returned: 99.1000E+36.
Group
Cursor
Syntax
CURSor:XY:RATIO<x>?
Examples
CURSor:XY:RATIO1? might return :CURSOR:XY:RATIO1 15 .8730E-3
indicating that the ratio of the X and Y positions for Cursor 1 is 15.8730E-3.
CURSor:XY:RDELta? (Query Only)
This query-only command returns the delta radius (Δr) value when the is set
to POLARCoord.
NOTE. This query is only valid when the CURSor:XY:READOUT is set to
POLARCoord. If the readout is set other than polar coordinates, the IEEE
representation of NAN (Not a Number) is returned: 99.1000E+36.
Group
Cursor
Syntax
CURSor:XY:RDELta?
2-146 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual

Tektronix DPO70000 Series Specifications

General

Brand	Tektronix
Model	DPO70000 Series
Category	Test Equipment
Language	English