Commands Listed in Alphabetical Order
MASK:FILTer
This command sets or returns whether the selected digital filter will be run on
the waveform data. The filter s imulates optical hardware. That is, it simulates
different ha
rdware for each of several different optical standards.
The digital filter runs on OC1, OC3, OC12, OC48, FC133, FC266, FC531,
FC1063, FC2
125Draft, Gigabit Ethernet, Infiniband 2.5Gb, 1394b, 393Mb,
786.4 3Mb, 1.572 Gb
Group
Mask
Syntax
MASK:FILTer {OFF|ON|<NR1>}
MASK:FILTer?
Related Com
mands
ACQuire:MODe
Arguments
ON enables the digital filter.
OFF disables the digital filter.
<NR1> = 0 disables the digital filter; any other value enables it.
Examples
MASK:FILTER ON enables the digital filter.
MASK:FILTER? might return :MASK :FILTER 1, indicating that the selected
digital filter will be run on the waveform data.
MASK:HIGHLIGHTHits
This command sets or returns whether or not hits in a mask are highlighted in
different colors than other waveform data. The default is On.
Group
Mask
Syntax
MASK:HIGHLIGHTHits {OFF|ON|<NR1>}
MASK:HIGHLIGHTHits?
Arguments
ON enables the mask:highlighthits function.
OFF disables the m ask:highlighthits function.
<NR1> = 0 disables the mask:highlighthits function; any other value enables it.
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-305
To Next Page
Loading...
Need help?
General
