Commands Listed in Alphabetical Order
Examples
HISTOGRAM:SOU
RCE CH1
enables the Channel 1 waveform to be compared
against the histogram box. The default time base, Main, is used for the histogram
display.
HISTOGRAM:SOURCE? might return :HISTOGRAM: SOURCE CH1, indicating that
the waveform
for Channel 1 is the source for the histogram.
HIStogram:STATE
This command sets or queries whether the histogram calculations are enabled.
This is equivalent to selecting Waveform Histograms from the Measure m enu.
Group
Histogram
Syntax
HIStogram:STATE {ON|OFF|<NR1>}
HIStogram:STATE?
Related Commands
HIStogram:MODe, MEASUrement:METHod
Arguments
<ON> enables histogram calculations.
<OFF> disables the histogram calculations.
<NR1> = 0 disables histogram calculations; any other value enables histogram
calculations.
Examples
HISTOGRAM:STATE ON enables histogram calculations.
HISTOGRAM:STATE? might return :HISTOGRAM:STATE 0, indicating that
histogram calculations are currently disabled.
HORizontal? (Query Only)
This query-only command returns all settings for the horizontal commands.
Group
Horizontal
Syntax
HORizontal?
Examples
HORIZONTAL? might return the following horizontal settings
:HORIZONTAL:DELAY:MODE 0;POSITION 50.0000;TIME
2-238 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual
To Next Page
Loading...
Need help?
General
