Commands Listed in Alphabetical Order
SEARCH:SEARC
H<x>:TRIGger:A:SETHold:CLOCk:SOUrce
This command sets or queries the clock source setting for a setup/hold trigger
search to determine where to place a mark. <x> is the search number.
Group
Search and Mark
Syntax
SEARCH
:SEARCH<x>:TRIGger:A:SETHo ld:CLOCk:SOUrce
{CH1|CH2|CH3|CH4|MATH1|MA TH2|MATH3|MATH4|REF1|REF2|REF3|REF4}
SEARCH:SEARCH<x>:TRIGger: A:SETHold:CLOCk:SOUrce?
Arguments
CH<x> specifies an input channel as the edge source, where <x> = 1, 2, 3 or 4.
MATH<x> specifies the math waveform as the search source, where <x> = 1, 2, 3
or 4.
REF<x> specifies the reference waveform as the se arch source, where <x> =
1, 2, 3 or 4.
Examples
SEARCH:SEARCH1:TRIGGER:A: SETHOLD:CLOCK:SOURCE MATH 1 sets the
setup/hold trigger clock source setting for search 1 to MATH1.
SEARCH:SEARCH1:TRIGGER:A: SETHOLD:CLOCK:SOURCE? might return
:SEARCH:SEARCH1:TRIGGER:A :SETHOLD:CLOCK:SOURCE CH1, indicating
that the s etup/hold trigger clock source setting for search 1 is set to CH1.
SEARCH:SEARCH<x>:TRIGger:A:SETHold:CLOCk:THReshold:CH<x>
This command sets or queries the clock threshold setting for a setup/hold trigger
search to determine where to place a mark. < x> is the search number or channel
number.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:SETHold:CLOCk:THReshold:CH<x>
{NR3|ECL|TTL}
SEARCH:SEARCH<x>:TRIGger: A:SETHold:CLOCk:THReshold:CH<x>?
Arguments
<NR3> is the clock level, in volts.
ECL specifies a preset ECL high level of -1.3 V.
TTL specifies a preset TT L high level of 1.4 V.
2-462 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual
To Next Page
Loading...
Need help?
General
